Vestil DGLED-12 Instructions D'installation

IMPORTANT SAFETY INFORMATION
CAUTION:
The individual user should take care to determine prior to use whether this device is
suitable, adequate or safe for the use intended. Since individual applications are subject to great
SET UP AND MOUNTING
CAUTION!
cable State and Local electrical codes may supersede these instructions.
CAUTION!
Disconnect power before installing
Installation:
1. Choose a location for each guide light unit that is visible to personnel and vehicles approaching the loading dock. It is advisable to
position the guide lights 2-3 inches below dock bumpers to protect units from impact with vehicles. IMPORTANT: See arrow inside of
2.
Position the back-panel of the unit on the intended mounting surface. Use the four (4) inner holes as a mounting template. Install
3.
fasteners to secure unit to the dock structure.
Wire each fixture to a suitable electrical supply. The power connection is made through the underside of the housing. Use wire nuts
4.
to connect the wires: (+) Red, (-) Black. Arrange the inner wires so they do not block LEDs. Use watertight connectors when
installed in outdoor or wet locations. IMPORTANT: Use watertight ½" EMT fittings if required by Code.
5. Place housing cover over mounted back panel and secure using the four (4) screws removed during installation set up.
WARNING!
WARNING!
local electrical codes.
Electrical Rating for single fixture:
LIMITED WARRANTY
to above, and the Purchaser, at its expense, returns the product or component parts to the Seller together with a report of defects, the Seller shall review the inspection report and
inspect the items and shall authorize, at its option, either the repair or replacement of any non-conforming products or component parts, whether on warranty, contract of negligence,
shall not in any case exceed the amount to be paid by the Seller in obtaining and repair or replacement of non-conforming products or component parts, and upon expiration of the
warranty period, all liability of the Seller shall be terminated. Incandescent bulbs incorporated into Tri Lite products are considered consumable items and are not covered by this
Lite products incorporating LED's.
have other rights, which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so that the above limitation of exclusion
may not apply to you.
Installation Instructions for Model DGLED-12
Loading Dock Guide Lights
@12 VAC/VDC, 650mA., 8W
-
@24 VAC/VDC, 330mA., 8W