Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 4 rubber inserts Ø5
- 2 plastic spacers Ø6 L10mm
- 2 plastic spacers Ø6 L5mm
- 4 screws BHC black big head Ø5x30
- 4 plastic washers Ø5
Fitting instructions
- Remove the original nose screen.
- Stick the plastic spacers on the inserts : those of 10 mm top and those of 5 mm down.
- Put the 4 rubber inserts instead of original ones. Fit the Ermax nose screen using the 4 screws Ø5 and
washers. Control it is well center before blocking all screws.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
FITTING INSTRUCTIONS
ADAPTABLE ON KAWASAKI Z 300 → ∞
« CAUTION »
ERMAX NOSE SCREEN
Estimated mounting time : 30mn
Publicité
