Ermax 0308039 Serie Notice De Montage page 2

Fitting kit
- 3 rubber inserts
- 2 screws BHC 5×25 (big head)
- 1 black plastic spacer Ø6L 5mm
- 3 plastic washers Ø5
- 2 black plastic spacers Ø6 L 10mm
- 1 screw BHc 5×20 (big head)
Assembly
- Remove the nose fairing (4 side screws).
- Mark the fitting holes' position. Drill progressively to
reach the diameter 9,5 mm (it is advised to turn quickly
the drill and to exert a slight pressure).
- On the nose screen, fit the screws, the washers, the
spacers and the inserts as shown on the photo.
- Fit the nose screen on the nose fairing and then the
whole on the motorbike.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
88 mm
41 mm
144 mm
67 mm
Spacer Ø6 L 5mm
« CAUTION »
FITTING INSTRUCTIONS
ERMAX NOSE SCREEN
ADAPTABLE ON SHIVER 2011 → ∞
Estimated fitting time : 30 mn
41 mm
144 mm
67 mm
35 mm
Spacers Ø6 L 10mm
Rubber inserts
caoutchouc
88 mm