Operating Procedures - ITC POWER TOOLS SPT125 Manuel De L'utilisateur

SPECIFICATIONS
Your new ITC 011353 comprises:
1 Variable Speed Orbital Jigsaw with Laser

1 Wood-cutting blade

1 Metal-cutting blade

1 Dust port adaptor tube

1 Hex key stored in the housing below the dust port

FEATURES:
 Voltage: 120 volts AC, 60Hz.
 Current rating: 650 watts, 5.5 amps
 Class 2 semi-conductor laser
 Electronic variable speed 500-3000 strokes per minute with thumb-wheel
control
 Three orbital cut settings
 Blade support bearing saves parts wear and tear
 Lock-on trigger
 Rear vacuum hose port allows connection to a vacuum cleaner with a 1-1/4"
(31.4 mm) ID hose
 Sliding blade safety shield
 Foot plate tilts 0-45 degrees L & R
 Cutting capacity: wood- 65 mm (2-9/16"); steel- 5 mm (3/16")
 Accepts "Universal" style jigsaw blades
 Double insulated
 C-UL-US listed
 Cord length: 1.8 m (6')
 Laser uses two AAA batteries

OPERATING PROCEDURES

LASER DEVICE
! NEVER LOOK INTO THE LASER BEAM. Any contact with the eyes by the
beam could cause injury. Do not use the laser when cutting reflective
materials.
! DO NOT AIM THE LASER BEAM AT ANYONE OR AT REFLECTIVE SUR-
FACES. Any contact with the eyes by the beam could cause injury. Ensure
the laser beam is turned on only when the tool is on a non-reflective workpiece
and as such it is aimed only at the work surface. Metals and other materials
like steel which can be highly reflective should only be cut without the use of
the laser.
! STORE OUT OF REACH OF CHILDREN. Equipment should be in a high
location or locked up to keep out of reach of children. It is not a toy.
! DO NOT TAMPER WITH THE LASER OUTPUT. Changing the performance of
the laser to increase its output is prohibited. Any claim for damages or injuries
resulting from not following these instructions will be refused.
BATTERIES
1. Use only two AAA batteries.
2. Lift the cover off the front of the laser device.
3. Orient the batteries for correct polarity and insert them.
4. Replace the cover.
5. Replace both batteries when the laser light becomes dim.
REMOVE BATTERIES IF TOOL IS TO BE STORED FOR ANY LENGTH OF TIME
 Batteries may leak and damage the laser if it is stored idle for more than
 months.
 Be careful with this tool. Striking or jarring it, especially on the laser housing,
can affect the accuracy.
 Other than batteries, there are no user-serviceable parts in the laser device.
4
All manuals and user guides at all-guides.com