West Bend QuikServe Mode D'emploi page 5

Toast
Rack
Browning
Control
Knob
Serving
Tray
1. Place toaster on a dry, level, heat-resistant surface, away from any edge or
flammable materials.
2. Plug cord into 120 volt AC outlet only. Open serving tray. Note: Toaster will
not function unless serving tray is open.
3. Set bread/bagel select switch to desired setting. When set at bread both sides
of food will be toasted. When set at bagel the cut side of food will be toasted.
4. Place a maximum of two slices of bread or bagel into the bread slot. Be sure to
place bagel into toaster with cut side to front as indicated on toaster.
5. Select desired toast color setting from 1 (light) to 6 (dark). We recommend you
start with setting 3 (medium) until you become familiar with your toaster. Note:
Toaster pastries, tarts and the like can ignite if over-heated. Toast at lowest
setting with constant attention.
6. Press the toast lever down until it locks into place. Power light will glow and
toasting cycle will begin. Note: Toaster must be plugged in and serving tray
open for toast lever to lock in place.
7. When selected color is reached, toast rack will open in bottom of toaster and
toast will slide out onto serving tray. Power light and toaster will turn off. After a
few seconds you will hear a click as the toast rack automatically closes. The
toast cycle can be stopped anytime by pressing the cancel button. If toasting
additional food, always allow a few seconds between toasting for toast rack to
close.
8. When finished toasting, unplug the cord from wall outlet and allow toaster to cool
before cleaning. Wipe serving tray to remove crumbs. Close serving tray when not
in use. Wrap cord around clips on underside of toaster for storage.
•
Some smoke and/or odor may occur upon first heating due to the release of
manufacturing oils – this is normal.
•
Some expansion/contraction sounds may occur during heating and cooling – this
is normal.
5
Bread Slot
Toast Lever
Power Light
Cancel
Button
Bread/Bagel
Select
Switch
Cord
Storage