Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 threaded threaded fasteners
- 4 screws 5×16
- 3 brackets
Assembly
- Remove the passenger saddle.
- Fit the threaded staple fasteners as shown in the photo below.
- Position the brackets as shown in the photo below.
- Before final tightening, offer the seat cowl up to bike and centre it (by adjusting position of fasteners if
necessary). Remove seat cowl and final tighten all screws to lock the brackets into position.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
FITTING INSTRUCTIONS
ADAPTABLE ON FZ 1 2006 → ∞
« CAUTION »
ERMAX SEAT COWL
Estimated assembly time : 15 mn
Publicité
