Safety; Safety Definitions; Safety Instructions For Operation; Operation - Hamron 002832 Traduction Des Instructions D'origine

10. Compressor switch
11. Charger connection
2

Safety

2.1 Safety definitions

Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note: Information that is necessary in a given situation.

2.2 Safety instructions for operation

Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Read and understand the instructions before you use the
product.
● Save these instructions and safety instructions for future
reference.
● Do not use the product for tasks other than its intended
purpose. The manufacturer cannot accept liability for any
damage that is a result of improper use.
● Use safety glasses. If you get battery fluid in your eyes,
rinse your eyes with clean water for at least 10 minutes
and then immediately seek medical attention.
● Keep the product away from moisture and water.
● Keep the product away from direct sunlight.
● Do not use the product if parts are missing. Speak to the
retailer if product parts are missing.
● Do not use the product if it is damaged or is defective.
Speak to an authorized service center.
● Do not let persons who do not have the required
experience, knowledge or training operate the product
without training or supervision.
● Do not repair the product. A damaged or defective
product must be repaired at an authorized service center.
The manufacturer cannot accept liability for any damage
that is a result of unauthorized repairs.
● Do not use a battery charger other than the one supplied
with the product.
● Make sure that the clamps cannot short-circuit.
2022_001
● Make sure that you connect the clamps to the correct
terminal on the battery.
● Make sure that the vehicle that you need to start is in a
well-ventilated area.
● Do not attempt to start a vehicle battery that is not a 12 V
battery.
● Do not use the product instead of the vehicle's own
battery.
● Keep the product in a dry and closed storage, away from
children, when the product is not in operation.
● Make sure that all switches are in the OFF position when
the product is not in operation.
● Make sure that all switches are in the OFF position before
you clean or do maintenance on the product.
● Clean the product regularly.
● Make sure that you follow local regulations when you
dispose the product.
3

Operation

3.1 To do a check of the battery

1
Press and release the USB/battery check button. The
battery charge indicator shows 1 of the status lights
that follow.
● The green status light flashes and an alarm signal is
given.
The battery has too high voltage. Make sure that the
product is charging correctly.
● The green status light flashes (no alarm signal).
The product is charged and ready to be used.
● The yellow status light comes on.
The product needs to be charged.
● The red status light comes on.
The product needs to be charged as soon as possible.
● The red status light flashes and an alarm signal is given.
Too low battery voltage. The product needs to be
charged.
● The red status light flashes, an alarm signal is given and
the product stops automatically.
Too low battery voltage. The product needs to be
charged.
2
Press and release the USB/battery check button
again to avoid unnecessary charging of the battery.
17