Holzmann WB162L Mode D'emploi page 13

OPERATION
Only use the product when it is in perfect condition. Before each use, visually inspect the
connecting parts to ensure that they are firmly seated.
HOLZMANN Maschinen GmbH
NOTE:


NOTE:


3. Assemble the drawer




4. Finish the workbench






www.holzmann-maschinen.at
No holes are pre-drilled.
Mount the workbench frame with screws (50 mm)
to the underside of the worktop (7).
Screw the side panels of the feet to the underside of
the worktop (8).
No holes are pre-drilled.
Screw the lower support to the legs of the
workbench frame on the left and right respectively
and to the divider in the middle (9).
Turn the workbench over.
Screw the two drawer side panels with the guide
rails to the cross surface of the drawer front panel
and the drawer back panel (10) respectively.
Place the drawer bottom in the drawer (11) and
secure it to the underside of the drawer.
Place the drawer handle on the drawer front panel
(12) and fix it on the inside of the drawer.
Repeat this procedure with the 3 other drawers.
Insert the vise into the openings and turn them in
with the lever (13).
Fix the workbench vise on the inside of the
workbench with the enclosed screw and washer
(13a).
Push the moveable part (14a) of the rail on the
inside of the workbench and the partition forward
(14b).
Place the 4 drawers in the rails of the workbench
(14).
Place the wood pegs in the respective openings (15).
Place the bench dogs in the holes of the workbench
(16).
OPERATION
13
WB162L