d2itsu ADDH-10C DIG Manuel De L'utilisateur page 20

This unit has 3-min lag due to the device for protecting circuit .In order to prolong
the compressor's working life, the compressor will not start until the unit has run
for 3 minutes.
Display
Shows the set % humidity level while setting, then shows the actual (+/– 5%
accuracy) room % humidity level.
FAN SPEED Pad
Controls the fan speed.
Press to select High or Mid or Low fan speed. Set the fan control to High for maximum moisture
removal. When the humidity has been reduced and quiet operation is preferred, set the fan control
to Mid or Low.
TIMER Pad
If unit is turned on and running in timer mode for 2hr or 4hr,can turn off the unit.
When unit stand by and running in timer mode for 2hr or 4hr can turn on the unit.
Other Instructions
BUCKET FULL Light
Glows when the bucket is ready to be emptied,or when the bucket is removed or not replacedin the
proper position.
Alarm
If the bucket is full or missing for more than three minutes, an alarm will soundfor about 10 seconds
to remind you to empty and replace the bucket.
Auto Shut Off
The Water Level Control Switch shuts off the dehumidifi er when the bucket is
full, or when the bucket is removed or not replaced in theproper position.
Auto Defrost
When frost builds up on the evaporator coils,the compressor will cycle off and
the fan willcontinue to run until the frost disappears.
Power Outage
In the case of a power outage or interruption,the unit will automatically restart,
in the settings last used, after the power is restored.
17