Samsung HW-M550 Manuel D'utilisation page 20

What are the bt reaDy and bt PaIrInG statuses?
• bt reaDy : In this mode, you can search for previously connected TVs or connect to the Soundbar
from a previously connected mobile device.
• bt PaIrInG : In this mode, you can connect to a new device. (While in "bt" mode, press and hold the
(Source) button for more than 5 seconds on the right side of the Soundbar or on the remote
control.)
noteS
• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.
• In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the
Soundbar and the Bluetooth device exceeds 10 meters.
• The Soundbar automatically turns off after 5 minutes in the Ready state.
• The Soundbar may not perform Bluetooth search or connection correctly under the following
circumstances:
– If there is a strong electrical field around the Soundbar.
– If several Bluetooth devices are simultaneously paired with the Soundbar.
– If the Bluetooth device is turned off, not in place, or malfunctions.
• Electronic devices may cause radio interference. Devices that generate electromagnetic waves
must be kept away from the Soundbar main unit - e.g., microwaves, wireless LAN devices, etc.
Disconnecting the Soundbar from the bluetooth device
Press the (Source) button on the right side panel or on the remote control, and then change to any
mode except "bt".
• Disconnecting takes time because the Bluetooth device must receive a response from the
Soundbar. (Disconnection time may differ, depending on the Bluetooth device)
• When the Soundbar is disconnected from the Bluetooth device, the Soundbar will display
"bt DISconnecteD" on the front display.
ENG - 16