Télécharger Imprimer la page

König Electronic ANT AMP Mode D'emploi page 2

Ampli d'antenne d'intérieur

Publicité

FEATURES:
For indoor use, suitable for two TVs.
Designed for TV full-band amplification.
Shielded metal housing with compact ABS plastic casing.
Built-in internal power supply for direct mains AC power.
OPERATING INSTRUCTIONS:
1. Connect a 75 ohm coax cable from the antenna to the INPUT terminal on the Amplifier.
2. Use a 75 ohm coax cable to connect the OUTPUT 1/2 terminal from the Amplifier to the TV/
FM receiver.
3. Simply plug the amplifier into a standard 230 V~ wall socket. Now it is ready to use.
4. Gain control: Rotate this control to vary the amount of gain for signals of different strengths.
Caution!
Do not expose this device to dripping or splashing water, Do not place object filled with
liquids, such as vases on this device. The MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily operable.
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
product from mains and other equipment if a problem should occur. Do not expose the product
to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Attention!
Keep this device away from dripping of splashing water.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or
damage caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic
products should not be mixed with general household waste. There is a separate
collections system for these products.
ENGLISH
Bandwidth
Gain
not ok
ok
Gain Control
Noise Figure
Max. Output
Impedance Input
Impedance Output
Power Source
To reduce risk of electric shock, this product should ONLY be opened
by an authorized technician when service is required. Disconnect the
40-862MHz
18dB
0-10dB
7dB
2x98dBµV
75 ohm
75 ohm
230V~ 50Hz / 2.8Watt
2
E
B
1
2
3
4
A
D
w
T
S
W
N
A
V
G
E
P
A
A
D
A
E
B
A

Publicité

loading