Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Photo1
Rubber spacers location
Photo 2
Screws to remove and replace
Fitting kit
- 4 rubber inserts
- 4 BHC 5×20 screws (small head)
- 2 fitting brackets
- 4 steel spacers Ø8 L: 10mm
Assembly
- Place the rubber inserts on the fitting brackets.
- Fit them on the nose screen thanks to the BHC 5x20 screws and plastic washers, by inserting the rubber spacers
between the nose screen and the fitting bracket (see photo 1).
- Remove the 4 screws of the handlebar holder. Place the 4 steel spacers into the holes of the original screw heads
(see picture 2).
- Place the whole nose screen / fitting brackets on the handlebar holder and fit the unit by using the provided BHc
8x40 screws : JAM FRONT SCREWS AT FIRST, and then tighten rear screws.
*
Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
ADAPTABLE ON Z 750 N LOOK Z 1000 2007/2012
- 4 Ø5 plastic washers
- 4 rubber spacers Ø5 L: 5mm
- 4 BHC 8×40 screws
Front screw :
stuck clamp
« CAUTION »
FITTING INSTRUCTIONS
ERMAX NOSE SCREEN
Estimated fitting time : 15 mn
Rear screw
Publicité
