HENX H36CF900HE Mode D'emploi page 13

Preparation
5.2
a. Obtain ear protection and safety
glasses. Wear them at all times while
operating the machine.
b. While operating the machine always
wear substantial footwear and long
trousers.
Do not operate the machine when
c.
barefoot or wearing open sandals. Avoid
wearing clothing that is loose fitting or
that has hanging cords or ties.
d. Do not wear loose clothing or jewellery
that can be drawn into the air inlet. Keep
long hair away from the air inlets.
Operate the machine in a recommended
e.
position and only on a firm, level
surface.
Do not operate the machine on a paved
f.
or gravel surface where ejected material
could cause injury.
g. Before using, always visually inspect
to see, that the bolts and other
fasteners are secure, the housing
is undamaged and that guards and
screens are in place. Replace worn
or damaged components in sets to
preserve balance. Replace damaged or
unreadable labels.
h. Never operate the machine while
people, especially children, or pets are
nearby.
Operation
5.3
a. Before starting the machine, make
certain that the feeding chamber is
empty.
b. Keep your face and body away from the
feed intake opening.
Do not allow hands or any other part of
c.
the body or clothing inside the feeding
chamber, discharge chute, or near any
moving part.
d. Keep proper balance and footing at all
times. Do not overreach. Never stand
at a higher level than the base of the
machine when feeding material into it.
Always stand clear of the discharge
e.
zone when operating this machine.
When feeding material into the machine
f.
be extremely careful that pieces of
metal, rocks, bottles, cans or other
foreign objects are not included.
g. If the cutting mechanism strikes any
foreign objects or if the machine
should start making any unusual noise
or vibration, immediately shut off the
power source and allow the machine
to stop. Disconnect the machine from
the supply and take the following steps
before restarting and operating the
machine: i) inspect for damage; ii)
replace or repair any damaged parts; iii)
check for and tighten any loose parts.
h. Do not allow processed material to
build up in the discharge zone; this may
prevent proper discharge and can result
in kickback of material through the
intake opening.
If the machine becomes clogged, shut-
i.
off the power source and disconnect
the machine from supply before
cleaning debris.
Never operate the machine with
j.
defective guards or shields, or without
safety devices, for example debris
collector in place. NOTE If a debris
collector is not used the text of the
example may be deleted.
Keep the power source clean of debris
k.
and other accumulations to prevent
damage to the power source or possible
fire.
Do not transport this machine while the
l.
power source is running.
m. Stop the machine, and remove battery
pack from the machine. Make sure
that all moving parts have come to a
complete stop - whenever you leave the
machine, before clearing blockages or
unclogging chute, - before checking,
cleaning or working on the machine.
n. Do not tilt the machine while the power
source is running.
Maintenance and storage
5.4
a. When the machine is stopped for
servicing, inspection, or storage, or
to change an accessory, shut off the
power source, disconnect the machine
from the supply and make sure that all
moving parts are come to a complete
English
13