Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 1 bracket
- 4 Ø6 plastic washers
- 1 Ø6 nylock nut
- 1 BHC 6x15 screw
- 1 Ø6 washer
Assembly
- Remove original chain guard and both rear brake pipe brackets (right hand side of swinging arm).
- Position the Ermax bracket as shown on photo.
- Position the hugger, ensuring that it is correctly centred in line with the tyre.
- Fix the hugger to the bracket, using the screws and washers supplied, and then use the original screws
and supplied washers for the other fixing points.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with
original tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
ERMAX REAR HUGGER ADAPTABLE ON
Original tyre Bridgestone Battlax BT 010 180/55 ZR 17
« CAUTION »
FITTING INSTRUCTIONS
600 SPEED FOUR 2003/2005
600 / 650 DAYTONA 2003/2005
Publicité
