Cooper Lighting Solutions Lumiere 1004-A1-RCS-FL-LED2790-F-BK-L1-UNV-RSM Instructions D'installation

IL509003EN
Installation Instructions - Lanterra - RSM (Round Surface Mount)
Instructions d'installation – Lanterne – MRS (montage rond en
surface)
Instrucciones de Instalación - Lanterra - RSM (Round Surface Mount)
WARNING
Make Certain Power is OFF before starting installation
or attempting any maintenance.
WARNING
Risk of Fire/Electric Shock. If not qualified, consult an
electrician.
WARNING
Risk of Electric Shock – Disconnect power at fuse or
circuit breaker before installing or servicing.
WARNING
Risk of Personal Injury – Fixture may become damaged
and/or unstable if not installed properly.
Do not mount luminaire within 6" of a combustible
● ●
surface.
Do not handle luminaire by the glass. Do not touch
● ●
LEDs.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
GENERAL: Upon receipt of the fixture, thoroughly inspect for any freight damage which should be brought to the
attention of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the
housing to assure you have received the correct material.
SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
APPLICATIONS: This lighting fixture is designed for outdoor lighting services, and should not be used in area of limited
ventilation or inside high ambient temperature enclosures. It must be stored in a dry location prior to installation. Do
not expose lighting fixture to rain, dust or other environmental conditions prior to installation and insertion of photo
control or shorting cap (if so equipped). Do not install the fixture near combustible materials or locate next to airflow
blocking surfaces within 6 inches. Best results will be obtained if installed and maintained according to the following
recommendations.
WARNING
Risk of Burn – Disconnect power and allow fixture to
cool before servicing.
N ote: These instructions do not claim to cover all
details or variations in the equipment, procedure,
or process described, nor to provide directions
for meeting every possible contingency during
installation, operation or maintenance. When
additional information is desired to satisfy a
problem not covered sufficiently for user's purpose,
please contact your nearest representative.
N ote: This lighting fixture has been shipped complete
with one of several mounting options. Please follow
the installation instructions specific to the catalog
part that you ordered.
N ote: Care must be taken not to set lighting fixture down
on optical lenses or lift the fixture in the lens area.
Specifications and dimensions subject to change
N ote:
without notice.
INS #
WIRING TABLE
POWER SUPPLY (INPUT)
BLACK (BK) - HOT
WHITE (WH) - NEUTRAL
GREEN (GN) - GROUND
PURPLE (PU) - 0-10V (+)
GRAY (GR) - 0-10V (-)