Hathaway QUICK SET Instructions D'assemblage page 4

ASSEMBLY INSTRUCTIONS
Assemble the table tennis surface #1 and table tennis surface #2 together with hinges #6 and
1.
screws #5 as shown below. Remove the paper on the EVA pad #4 and stick the pad #4 to the corners
of the table tennis surface as shown below.
NOTE: Be sure to measure surface table
is to be placed on, so EVA pads #4 are
positioned to contact this surface.
EVA Pad (#4)
2.
Put the assembled table tennis tops on the table surface carefully, position together, then clip the net
post clips and net onto the tennis surface as shown below.
NOTE: If tennis table is used over billiard table it is recommended that the EVA support block be
placed under the center of the table tennis surface for extra support.
Hinge (#6)
Screw (#5)
Table Top #2
Table Top #1
1
2
Hinge (#6)
Screw (#5)
#2
2
1
#1
Remove the cover on the EVA
pad and stick it inside the clips
as shown.
4