jbc ADVANCED AD 2200 Mode D'emploi page 4

ENGLISH
Structure of Advanced soldering stations
system
The Advanced series has 3 basic modules giving
you full flexibility for choosing what you need for the
work in hand, the modules being supplied separately.
Control unit
- AD 2200 230V
Handpieces
- 2010
Power: 20W. For high precision work, SMD, etc.
- 2210
Power: 20W. For high precision work, SMD, etc.
- 2045
Power: 50W. For general soldering work.
- 2245
Power: 50W. For general soldering work.
Two versions of soldering iron handpieces covered
with heat isolater are available:
- 2045 Thermo-isolated handpiece ref. 2045110.
- 2245 Thermo-isolated handpiece ref. 2245110.
Cartridges
- Range of cartridges 2010 (for the 2010 handpiece)
on page 27.
- Range of cartridges 2210 (for the 2210 handpiece)
on page 27.
- Range of cartridges 2045 (for the 2045 handpiece)
on page 26.
- Range of cartridges 2245 (for the 2245 handpiece)
on page 26.
The handpieces and cartridges 2210 and 2245 comply
with the MIL-SPEC-2000 referring to the potential
difference between the soldering tip and ground
connection, must be less than 2 mV.
For a station to work properly, a control unit, a
handpiece and one cartridge are needed.
Control Unit AD 2200
The station is supplied with:
- Control unit which incorporates a stand with
sponge and cartridge extractor.
- Connection cable to mains.
- Instructions manual.
- Transport packaging.
Technical specifications
- Temperature selection from 100 to 371°C (±5%).
- Power: 55W.
- Safety transformer, mains separator and double
isolation, with integrated fuse of temperature
protection.
- Input: 230V 50Hz. Output: 24V
Ref. 2200200
- Electrical protection Class I.
- Total weight of unit: 2.6 Kgs.
Ref. 2010000
- ESD protected housing.
Typical surface resistance: 10
Ref. 2210000
square.
- Complies with CE standards on electrical safety,
electromagnetic compatibility and antistatic
Ref. 2045000
protection.
- Equipotential connector is earth connected to the
Ref. 2245000
plug feed of the station.
RECOMMENDATIONS FOR USE
For soldering
- Clean the contacts and the printed circuit to
be desoldered of dust or dirt.
- Preferably select a temperature below 350°C.
Excess temperature may cause the printed
circuit tracks to break loose.
- The tip must be well tinned for good heat
conduction. If it has been inoperative for any
length of time, it should be retinned.
Safety measures
- Incorrect use of this tool may cause fire.
- Be cautious when using the tool in places
where inflamable products are stored.
- Heat can fire up inflamable products even
when they are not at sight.
- Do not use when the atmosphere is explosive.
- Place the tool back on its stand in order to let
it cool down before you store it.
OPERATION
LED lights
Red LED -ON- when lit, it indicates that the station is
plugged in the mains.
Green LED -READY- when lit, it indicates that the
system is ready and correctly set for working.
The green led light is on after a few seconds, is the
time needed to carry on the self-checking system.
The green light is pulsing when the soldering iron is
in sleep mode.
2
5 11
-10 Ohms/