Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS (CONT.)
FIG. 11
15.
Attach the Control Box (#16) to the middle of
16. Run the rest of the Control Wire through the loops on the bottom side of the Ball Return Net (#35). Hold the Control
Wire on
Tube 11
(#11) using the Self-Stick Straps (#34) as shown in FIG.11.
16
X1
30
X2
34
X2
FIG. 12
17.
Connect the Sensor Wire from Switch Sensor (#15) to the Electronic Scorer (#14) as shown in FIG.12.
Connect the Control Wire to the Electronic Scorer (#14) as shown in FIG.12 and 12A.
FIG. 12
NOTE: Control Box Wire must be plugged into Electronic Scorer and Controller turned on, along with Electronic
Scorer, for Scorer to work. Scorer will NOT work until this is done.
Tube 11
FIG.11A
16
11
30
Control Wire
11
34
(#11) using two Bolts (#30) as shown in FIG.11A.
FIG.11
35
12
Publicité
