Hathaway MONTEREY Instructions D'assemblage page 9

ASSEMBLY INSTRUCTIONS (CONT.)
ATTACHING CLOTH TO RAILS
Corner Pockets (Cont.):
7. Turn the rail over and at the corner pockets fold the cloth over the
mitered edge as shown in Figure 5, stretching the cloth tightly and
working out the wrinkles as you staple in the area shown in Figure 5.
Figure 6
Figure 7
Side Pockets:
11. At the side pocket, stretch the cloth tightly over the nose of
the cushion and staple in three places as shown in Figure A.
12. Slit the cloth up to the edge of the cushion nose as shown
in Figure B, then firmly pull the small strip to the rear of the pad.
13. Hold the small fold in place with your thumb and forefinger
and firmly fold it down over the facing. Now staple at the rear of
the facing and at the bottom of the rail as shown in Figure C.
14. Trim excess cloth as required.
8. Pulling the cloth tightly over the rear edge of the pocket
facing, staple three places at Figure 6, location X.
9. If the rail is an end rail repeat step 8 at the other end of
the rail. Then starting at the center of the rail stretch the
cloth tightly over the cushion and staple at the center on
the bottom of the rail - working toward each end (Figure 6).
10. Trim any excess cloth from the bottom of the rail
(Figure 7).
Figure 5
9