Youngman BoSS X Série Guide D'utilisation page 14

6.1 autocollants situes sur les X-series
La position exacte des autocollants et de la
plaque Des X-Séries est précisée ci-dessous.
01
02
03
04
05
07/08
06
10
11 12 13
24
09
14
Boss X-series instructions for use
6.1 autocollants situes sur les X-series
01
02
InstructIons
for use
03
05
EnsurE both maintEnancE props arE in position bEforE
undErtaking maintEnancE on thE raisEd platform.
06
Fork LiFting
Point
Pass transit
through here
On all four forklift and transit strap points
07
To lower The plaTform wiThouT
power in an emergency
Turn The valve on The Pressure
1
loss valve on The hydraulic ram
anTiclockwise unTil iT will noT
Turn any furTher
Turn The valve adjacenT To This
2
label anTiclockwise unTil The
PlaTform begins To descend.
To sToP The PlaTform aT any
Time, Turn The valve clockwise.
Prior To The resToraTion of Power Turn boTh
valves clockwise unTil fully TighT and Then use
The handseT conTroler in accordance wiTh The
insTrucTions for use.
Do noT uSe a preSSure waSher on ThiS SiDe
of The BaSe uniT unleSS BoTh ruBBer plugS
are in poSiTion
09
Située a l'extrémité du châssis, comme
indiqué sur la page opposée.
10
Charging Cables
tray
12
Charger
indiCator Lights
aC Charge Charge Charging
Power to 80% of remaining indiCator
suPPLy battery 20% of
CaPaCity battery
CaPaCity
14
eMerGencY
stoP
youngmangroup.com
04
Pressure loss
valve
In the event of a loss of power or
hydraulIc pressure turn the valve
antIclockwIse untIl It wIll not turn any
further.
prIor to the restoratIon of power and
or hydraulIc pressure close thIs valve
by turnIng clockwIse.
MaxiMuM
WheeL
Load
450kg
straPs
08
X X X
11
!
Attention
Press the emergency stoP button
on the hAndset And remove the
key Prior to chArging.
Power suPPly: 110 or 240 volts.
select the APProPriAte cAble
from the trAy under the PlAtform
Access steP And Plug in below.
13
Battery Charge
level indiCator:
led displays
Battery Charge
level
25