Hayward RF252 Guide Rapide

1-Outlet Wireless Remote Control with Single Keychain Transmitter
RATING: 125VAC/60Hz/8A/1000W Tungsten
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including interference that may cause undesired operation.
The user manual or instruction manual or unintentional radiator shall caution the user that changes or modifications not expressly
approved by the party responsible for compliance could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the
FCC and Industry Canada Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interferences to radio communication.
There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferences to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
4. Consult the dealer or an experienced radio/ TV technician for help.
WARNING:
This product must be used with a GFCI protected outlet for outdoor use and with swimming pools.
BATTERY INFORMATION AND REPLACEMENT:
The Remote Control uses a 3-volt CR2032 lithium battery. To replace, slide off the battery cover on the back of the Transmitter. Insert
a new CR2032 lithium battery, make sure to match up the + and – polarity markings. To test, press the ON or OFF buttons to make
sure the LED lights up. Slide the cover back in. Do not dispose of batteries in fire. Batteries may explode or leak.
CAUTION:
1. Only use the batteries specified and be sure to match the + and – polarity markings.
2. DO NOT mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be used for a long time.
5. Do not dispose of batteries in fire. Batteries may explode or leak. As with all small items, these batteries should be kept away
from children. If swallowed, seek medical attention immediately.
Instructions:
Insert the Remote Base's 3-prong plug into a grounded outlet. If using outdoors, be sure to plug into a GFCI approved outlet. Plug
appliance into outlet located on bottom of Remote Base. Using the Wireless Remote Control, press ON button to activate device.
RF252（28075） Outdoor Remote Power Socket