Signature Control Systems EZ Pro Jr. Indoor 8204 Guide D'installation Et De Programmation page 22

TECHNICAL DATA
1. Transformer
24 VAC internal transformer; 20 VA, .83A for zones and logic. The transformer
can run a pump or master valve and one zone valve, maximum.
2. Surge Protection
600 watts TVS on zone outputs 9J Mov on secondaries.
(see Circuit Breaker below)
3. Sensor Operation
™
The EZ Pro
without a sensor. Sensors must have normally closed connections (leads).
The factory-installed jumper wire must be in place if no ensor is used.
4. Zone Lines
™
The EZ Pro
concurrently, providing one is the pump/master valve. Each zone output can
operate one or two solenoids.
I inrush .52A max
I hold .33A max
5. Temperature Range
Operating: -20° to +55° C (23° to 131° Fahrenheit)
Storage: -30° to +85° C (-22° to 185° Fahrenheit)
18
Jr. Indoor is configured to operate the controller with or
Jr. Indoor will operate a maximum of two (2) solenoids