Executive Audio EQL-215 Notice D'utilisation page 7

REAR PANEL
6. LOW CUT FREQUENCY CONTROL
To cut down unwanted signal, this control determines the roll-off frequency of the High-Pass Filter (HPF) in the instrument.
The roll-off frequency cans de adjusted from
HPF can be efficiently used to cut down the "HUM" noise from preceding instruments, or to prevent the low-frequency
resonance while the speakers are installed in an enclosed acoustic environment.
8. POWER CORD
This cord is used to connect the AC power source to your equalizer.
CAUTION: DO NOT REMOVE THE CENTER GROUNDING PIN.
9. FUSE HOLDER
This fuse holder contains an AC primary fuse. This fuse should be replaced by the same type fuse when this is blown out. If
they continuously blow, stop replacing fuse and refer servicing to qualified personnel.
10. INPUT/OUTPUT CONNECTORS
1/4" TRS
The TRS (Tip Ring Sleeve) connector is balanced and wired as Tip=Hot (+), Ring= Cold (-), and the Sleeve = Ground.
CAUTION: Only one of these sockets can be chosen for audio connection at the same time.
XLR
The XLR input connector is balanced and wired as Pin2=Hot (+), Pin3=Cold (-), Pin1=Ground
CAUTION: Only one of these sockets cans de chosen for audio connection at the same time.
All manuals and user guides at all-guides.com
10Hz to 250Hz by turning this knob. Because of its high roll-off slope, the
7