Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
SYMPTOM
Pilot will not light
Burners won't light
Front or rear burner
won't light
Burner not hot enough
POSSIBLE CAUSE
Gas supply off
Air in lines
Pilot valve not on
Gas supply off
Air in lines
Pilot valve not lit
Control not on
Water in burner
Damaged temperature control,
Burner or other internal
component
Temperature control not set
Shutter or nozzle out of
adjustment
Damaged temperature control,
burner or other internal
component
12
SUGGESTED REMEDY
Check main / unit gas valves
Turn pilot valve on. Attempt to
light pilot every 15 sec.
Turn pilot valve on / adjust
Check main / unit gas valves
Turn gas valve on. Attempt to
light pilot every 15 sec.
Turn off gas - allow unit to
vent for 5 minutes. Turn gas
back on and light pilot
Turn temperature control to ON
Set to desired setting when lit
Remove burner and dry
thoroughly
Contact Authorized Wells
Service Agency for repairs
Adjust for desired temperature
Contact qualified technician for
adjustment
Contact Authorized Wells
Service Agency for repairs
NOTE: There are no user
serviceable components in the
burner assemblies or in the con-
trol valves. In all cases of dam-
age or malfunction,
contact your Authorized Wells
Service Agency for repairs.
Publicité
