Jump-N-Carry JNC550A Mode D'emploi page 4

• The Jump-N-Carry provides plenty of power for starting vehicles – more than
enough to start most cars.
• The Jump-N-Carry will power and charge most small electronic devices via its
USB output port.
• The Jump-N-Carry will power most 12VDC accessories equipped with a male
12 Volt plug. The DC outlet features automatic overload protection.
• The unit features a test switch and battery status display, which will provide a
snapshot of the internal battery's state of charge.
• The Jump-N-Carry features convenient side-mounted holsters with cable tracks
for easy cable and clamp management. Always re-wrap cables and re-holster the
clamps after each use.
• The Jump-N-Carry contains the latest technology with its 12 Volt sealed,
non-spillable battery and may be stored in any position.
Battery Status Indication
Press and hold the "V" (Voltage Status) Button to show the battery status on the display.
The message seen on the display corresponds to the battery's state of charge:
• I f the battery's voltage is less than 12.4V, the display will flash the voltage and
then show CHG continuously, indicating the unit should be charged immediately.
• I f the battery's voltage is between 12.4-12.8V, the display will show the battery's
voltage and then flash CHG three times, indicating the unit is in need of charge.
• I f the battery's voltage is above 12.8V, the display will alternately flash the
battery's voltage and FUL, indicating that the unit is fully charged.
Note: Upon initial purchase, charge your Jump-N-Carry until the display reads FUL.
Recharge the Jump-N-Carry using a household extension cord connected to the built-in
charger in the back of the unit.
1. Connect the female end of the extension cord to the charger plug on the back of
the unit. The charger plug has two blades and resembles a standard household
plug that would fit into a 120 Vac wall receptacle.
2. Connect the male end of the extension cord to the AC outlet.
3. C harge until the dispay reads FUL.
Note: The unit can remain connected to AC power indefinitely without adverse
consequences. The charging system is fully automatic and will only consume
power as need to maintain the onboard battery.
Note: If the display shows Er3 when you connect an extension cord to charge,
the internal battery is either damaged or too discharged to accept a charge.
Features
Recharging
4