Télécharger Imprimer la page
LEGRAND Walkercell PK100 Notice D'installation
LEGRAND Walkercell PK100 Notice D'installation

LEGRAND Walkercell PK100 Notice D'installation

Publicité

Liens rapides

No: IP0125R2 – 0321
Catalog Number(s) • Numéro(s) de Catalogue • Número(s) de Catálogo:
PK100, PK150, PK200, PK250, PK300, PK325,
PKER-10, PKER-15, PKER-20, PKER-25, PKER-30, PKER-35, PKER-40, PKER-45, PKER-50, PKER-55
Country of Origin • Pays d'origine • País de origen: Made in USA • Fabriqué en USA • Hecho en USA
IMPORTANT:
Please read all instructions before
beginning installation
Legrand electrical systems conform to and
should be properly grounded in compliance with
requirements of the current National Electrical
Code or codes administered by local authorities.
All electrical products may present a possible
shock or fire hazard if improperly installed
or used. Legrand electrical products may
bear the mark of a Nationally Recognized
Testing Laboratory and should be installed
in conformance with current local and/or the
National Electrical Code.
WIREMOLD
Walkercell
PK Series Preset Insert
Insert prédéfini de Série PK
Inserto de preajuste de la
Serie PK
Installation Instructions • Notice d'Installation• Instrucciones de Instalación
IMPORTANT :
Veuillez lire l'ensemble des
instructions avant de commencer
l'installation.
Les systèmes électriques Legrand sont
conformes au Code National de l'électricité
(National Electrical Code) ou aux codes
locaux en vigueur et doivent être mis à la terre
conformément à ces codes.
Tous les produits électriques peuvent présenter
un risque d'électrocution ou d'incendie s'ils ne
sont pas installés ou utilisés correctement. Les
produits électriques Legrand peuvent porter la
marque d'un laboratoire reconnu et doivent être
installés conformément au Code national de
l'électricité et/ou aux codes locaux en vigueur.
®
/Walkerdeck
®
®
IMPORTANTE:
Lea todas las instrucciones antes
de comenzar la instalación.
Los sistemas eléctricos Legrand cumplen con
los requisitos del Código Eléctrico Nacional
(National Electrical Code, NEC) actual o con los
códigos impuestos por las autoridades locales y
deben conectarse a tierra consecuentemente.
Todos los productos eléctricos pueden
presentar un riesgo de descarga o incendio
si se los instala o utiliza incorrectamente. Los
productos eléctricos Legrand pueden llevar la
marca de un laboratorio de pruebas reconocido
a nivel nacional y se deben instalar conforme al
código local en vigencia o al Código Eléctrico
Nacional.

Publicité

loading

Sommaire des Matières pour LEGRAND Walkercell PK100

  • Page 1 Legrand electrical systems conform to and Los sistemas eléctricos Legrand cumplen con should be properly grounded in compliance with los requisitos del Código Eléctrico Nacional Les systèmes électriques Legrand sont...
  • Page 2 Steel Mudcap Couvercle en acier de protection contre la boue Tapón para lodos fabricado en acero 3/16" [4.8 mm] Diameter Steel Pop-Rivet Rivet pop en acier de 3/16 po [4,8 mm] de diamètre Remache de acero de 3/16" [4.8 mm] de diámetro PK Series Preset Insert Insert prédéfini de Série PK Inserto de preajuste de la Serie PK...
  • Page 3 Slide the preset into position toward Faites glisser l’insert prédéfini pour Deslice la pieza de preajuste en the hooked end until the preset insert le mettre en position vers l’extrémité su posición hacia el extremo rivet hole is aligned with the rivet hole accrochée jusqu’à...
  • Page 4 Vuelva a colocar el tapón para lodos. No: IP0125R2 – 0321 860.233.6251 1.877.BY.LEGRAND www.legrand.us © Copyright 2021 Legrand All Rights Reserved. www.legrand.ca © Copyright 2021 Tous droits réservés Legrand. © Copyright 2021 Legrand Todos los derechos reservados.

Ce manuel est également adapté pour:

Walkercell pk150Walkercell pk200Walkercell pk250Walkercell pk300Walkercell pk325Walkercell pker-10 ... Afficher tout