Turning On/Off; Connecting To A Network - LincPlus P2 Mode D'emploi

2. A fully discharged battery takes about 5 hours to fully charge;
3. When the battery is being charged, the LED indicator light is red. When the battery has been fully charged, the LED
indicator light is green.

Turning on/off

Turning on the device
Note:
This LincPlus P2 has been preinstalled with Windows 10. You will need to perform an initial setup before the laptop can be
used.
1. Press and hold the Power button for 2 seconds to turn your Device on. The lock screen will appear;
2. The Device is now ready for use.
Note:
If the login screen is not enabled in Windows, you will be taken directly from the lock screen to the start screen.
Turning off the device
You can turn off the device in two ways:
1. Press and hold the Power button for a minimum of 4 seconds;
2. Click on the shutdown confirmation screen to confirm turning the device off.
Connect to Wi-Fi
Turning On/Off Wi-Fi:
1. Select the Wi-Fi icon in the notification area, in the lower-right corner of the screen, to view the available Wi-Fi hot spots;
2. Select available Wi-Fi icon to establish a connection.

Connecting to a network:

1. Select the Wi-Fi icon in the notification area, in the lower-right corner of the screen, to view the available Wi-Fi hot spots;
2. Select an available network from the list and select Connect;
3. Input the password, if necessary, then select Connect to begin an internet connection.
Inserting a MicroSD Card (sold separately*)
1.Align the MicroSD Card so that the pins are pointed toward the card slot;
2. Push the MicroSD Card into the card slot until it locks into place.
Removing a MicroSD Card
Caution: Removing the MicroSD Card while it is in use may cause data loss or result in application errors. (Ensure all data is
saved to the MicroSD Card before removing.)
1. Select the Tray button in the notification area
2. Select Safely Remove Hardware;
3.Select Eject XXXX SD Card. A message will appear confirming that the MicroSD Card can be safely removed. If a warning
message appears stating that the MicroSD Card cannot be removed, ensure all data transfers involving the MicroSD Card are
complete;
4. Press down the MicroSD Card to release it;
5. Slide the card out after it ejects from the MicroSD Card slot.
* MicroSD card sold separately. Use only compatible memory cards. Incompatible memory cards may cause damage to the
laptop and corrupt the data stored on the card.
3