Publicité
Les langues disponibles
Les langues disponibles
Functions
The Anti-Griddle appliance provides a cold
surface that allows the user to rapidly freeze, or
partially freeze, a wide variety of ingredients.
Standard features include:
• Fixed -20°F (-29°C) working temperature
• 136 inch² (877 cm²) freezing surface
• Simple operation and maintenance
OPERATION
Before turning on the Anti-Griddle appliance
coat the cooking surface in a thin film of
cooking oil. This will prevent any sticking
issues.
Place the Power Switch / Circuit Breaker on
the front of the unit to the ON position. The
working surface will begin cooling and achieve
working temperature in approximately 10 to
15 minutes.
The unit should always rest for at least 15
minutes between being turned off and being
turned on again. Resting the unit for a shorter
time can destroy the heat exchanger and the
working surface won't freeze anymore.
WARNING
The working surface reaches -20°F (-29°C).
Avoid direct contact with skin while operating
the unit. Always allow the surface to return
to room temperature before cleaning or
performing maintenance. Use the cover
provided with the unit to prevent accidental
contact while not in use.
6
CAG700_USC_IB_C19.indd 6
Care & Cleaning
CLEANING THE WORKING SURFACE
To remove residue and ice from the working
surface while operating the unit, a non-metal
spatula or scraper can be used. Pure grain
alcohol may also be used to clean the working
surface during operation.
The Anti-Griddle appliance can be cleaned
using a mild detergent. Be sure to turn
electrical power to the unit OFF and allow
working surface to return to ambient
temperature before cleaning.
CAUTION
Avoid using water-based solutions to clean the
working surface during operation as freezing
will occur rapidly.
CLEANING THE AIR FILTER
To keep the refrigeration system operating at
optimum cooling capacity, the front and back
air vents and reusable filter should be kept free
of dust and dirt. They should be checked on a
scheduled basis and cleaned as required.
Be sure electrical power is OFF before cleaning
the air filter.
Remove the filter for inspection and cleaning
as follows:
1. Position the unit so that the front overhangs
the countertop just enough to allow access
to the filter compartment (approximately
2–3"/ 5.1–7.6cm).
2. Rotate the filter-retaining clips 90° to
provide clear access to the filter (it may be
necessary to first loosen the nuts with a
⁄
"/ 8mm nut driver).
5
16
Retaining Clips
15/1/19 2:56 pm
Publicité
