OK-LINE E-CORNER Flex TQD Instructions De Montage page 15

7. Setting the new lowest display and height range (
The desk frame ships defaulted to its minimum and maximum height limits. These steps allow the upper and lower limits to
be adjusted to your preference:
S
Press button and hold for 3 seconds, handset display
.
Press UP or DOWN. It will display
S
Press button to enter. It will display
: Sets the lowest position height display.
:Sets a new minimum desk height
:Sets a new maximum desk height
If , or
is already set, please drive the table-frame to the previously set height to change the value.
Press UP or DOWN. It will display
to set the lowest height display, press
Press UP or DOWN ,It will display
to set a lowest height position, press
Press UP or DOWN ,It will display
to set a new highest height position, press
8. Manufacturer Setting (
Factory use, please ignore this programming.
9. Reminder setting (
To get a healthier working style, the desk can remind you to stand up when you sit for a long time. You can set it by doing the
following:
S
Press button and hold for 3 seconds, handset displays
Press UP or DOWN go to display
S
Press to enter. It will display
Press UP or DOWN to select the time reminder you want, (
Note: When the handset time reminder beeps, press any button to make it disappear; the time reminder will last for 30 se-
conds if no buttons are pressed.
10. Setting bounce height (
S
Press button and hold for 3 seconds, handset display
.
Press UP or Down to display
S
Press button to enter. It will show the current bounce height.
Press UP or DOWN to get the bounce height. Press
11. Restore Factory Defaults (
S
Press button and hold for 3 seconds, handset display
.
Press UP or DOWN to display
S
Press to enter. It will display
S
Press to confirm, wait 2 seconds, it will display
12.Fatigue test mode (
Factory use, please ignore this programming.
.
, press UP or DOWN. It will display
S
, press button to enter. It will display the current lowest height. Press UP or DOWN
S
to confirm .
S
. Press button to enter. It will display the current lowest height. Press UP or DOWN
S
to confirm .
S
. Press button to enter. It will display the current highest height. Press UP or DOWN
S
to confirm .
)
)
.
. 0.0 is the standard and means no time reminder (H means Hour).
)
.
)
.
and flash.
)
)
S
. Release button, press
S
. Release button, press
means 1.5 hours), press
S
. Release button, press
S
to confirm, wait 2 seconds, it will display the current height.
S
. Release button, press
. Perform a reset as mentioned under troubleshooting.
E-CORNER Flex TQD
S
button again to enter, it displays
and .
S
again to enter, it displays
S
to confirm.
S
button again to enter, it displays
S
button again to enter, it displays
.
15