Publicité
Les langues disponibles
Les langues disponibles
LED-driver installation instruction
Please read this instruction before installation and keep it for future reference.
Model name: LED-driver
Technical parameter:
Model No.
IN
DRL8W
AC220-240V, 50Hz
DRL15W
AC220-240V, 50Hz
DRL30W
AC220-240V, 50Hz
Model: drivers are constant voltage type LED drivers, while others are of constant current type.
For led used only. tc: 85°C max., ta: 45°C max.
Remark: Comply with CE standard, with anti-EMI, short-circuit, over-voltage, and over-circuit protection reset
functions.
Caution:
1, These products are SELV LED drivers.
2, Load of the output shall not exceed the rated power.
3, Make sure to turn off the power before installation.
4, To be used where is ventilated, and the cord length should be 200mm minimum, and 2m max, between the LED
driver and the LED lamps.
5, Avoid output terminal to be short circuited. Environment temperature for the driver shall not exceed Ta that
shown on the driver.
6, Installation shall be done by qualified technician.
7, Primary cable shall be 0.75 mm
8, Output voltage of the LED drivers are high, please provide adequate insulation to the terminals of load that
connected to output.
Installation procedures:
1, Turn off the power before installation
2, Connect circuit as the circuit diagram fig. 1 indicates.
3, Connect primary cable to mains supply, and connect the secondary cables to led lighting.
4, Install the LED driver to where is appropriate and fix it steadily.
5, Make sure all the cables connected correctly.
6, Turn on the power, ready to use.
Fig. 1
Version 2.4
OUT
DC12V, Max 670mA
DC12V, Max 1250mA
DC12V, Max 2500mA
2
. Secondary cable shall be 0.5-1.0 mm
Charge
0... 8W
0...15W
0....30W
2
Publicité
