F6-Boost General Safety Instructions - JB F6-BOOST Manuel

F6-BOOST GENERAL SAFETY INSTRUCTIONS

Please read, follow and understand the contents of this entire manual, with special attention given to Danger,
Warning and Caution statements.
FOR USE BY PROFESSIONALLY TRAINED AND CERTIFIED OPERATORS ONLY. MOST STATES,
COUNTRIES, ETC., MAY REQUIRE USER TO BE LICENSED. PLEASE CHECK WITH YOUR
LOCAL GOVERNMENT AGENCY.
DANGER:
The recovery tank used with this contains liquid refrigerant. Overfilling recovery tank may cause
a violent rupture resulting in severe injury or even death. As a minimum, please use a
scale to continuously monitor recovery tank weight.
DANGER:
EXPLOSION RISK! This equipment can be used in Class I and II, Division 2 and Class III,
Divisions 1 And 2 Hazardous (Classified) Locations. Technicians should be fully trained on
services in this hazardous location.
DANGER:
ELECTRICAL SHOCK HAZARD: Always disconnect power source when servicing this
equipment.
WARNING:
Do not use equipment in the vicinity of spilled or open containers of gasoline or other
flammable substances.
WARNING:
All hoses may contain liquid refrigerant under pressure. Contact with refrigerant may cause
frostbite or other related injuries. Wear proper personal protective equipment such as safety
goggles and gloves. When disconnecting any hose, please use extreme caution.
WARNING:
TO REDUCE RISK OF FIRE: Avoid use of an extension cord because extension cord may
overheat. If you must use an extension cord, use 10 awg minimum.
WARNING:
Avoid breathing refrigerant vapors and lubricant vapor or mist. Breathing high concentration
levels may cause heart arrhythmia, loss of consciousness, or even cause suffocation. Exposure
may irritate eyes, nose, throat and skin. Please read manufacturer's Material Safety Data Sheet
for further safety information on refrigerants and lubricants.
WARNING:
Make certain all safety devices are functioning properly before operating equipment.
CAUTION:
To avoid cross contamination of refrigerant and potential leakage to the atmosphere, proper
hoses and fittings should be used and checked for damage.
CAUTION:
To avoid overfilling refrigerant tank, read and follow manufacturer's recommended filling
instructions for refrigerant being recovered.
CAUTION:
This equipment is intended for use of one refrigerant at a time. Mixing of different refrigerants
will cause your recovered supply of refrigerant to become contaminated.
Note: It is very expensive to destroy mixed or damaged refrigerants.
JB INDUSTRIES • F6-BOOST Operating Manual • 630.851.9444 • sales@jbind.com
3