Publicité
Les langues disponibles
Les langues disponibles
NOTICE
The Boat Unit should be mounted in the helm
or as near as possible to the driver position of
the boat.
FAILURE TO FOLLOW THESE INSTALLATION
INSTRUCTIONS COULD RESULT IN FIRE,
ELECTRIC SHOCK, OR OTHER INJURY OR
DAMAGE.
We recommend that the installation of the
NOTICE
WiMEA in your boat is performed by skilled
personnel familiar with electric wiring, or by a
professional mechanic or electrician. This is to
prevent any malfunction of the device related
to installation.
NOTICE
You can choose to keep the original kill switch.
If so, connect WiMEA in series if you have Open
to stop principle or parallel to the existing kill
switch if you have a Close to stop principle.
Please note that you always have to use your
existing kill switch when using this setup.
TIP
It may be easier to connect the kill switch signal
wires to the Connection Cable before mounting the
Boat Unit completely in your helm, depending on
your helm/boat. Connect the wires as described in
section "Connecting the wires". Then connect the
Boat Unit Cable and the Connection Cable by
connecting the male and female 5-pin IP67
Connectors before doing final mounting of the Boat
Unit. Connect the Boat Unit Cable to the Connection
Cable between bullet point 3 and 4 on page 19,
"Mounting the Boat Unit".
20
WARNING
WiMEA will not stop the engine when falling on
board your boat. You can stop the engine at any
time by pressing the button on your MOB Unit
or Boat Unit.
Connecting the Wires
Do not touch or cut any existing wires or
NOTICE
electrically conducting components before you
make sure the main voltage switch is OFF. Only
set the main voltage switch to ON after you are
finished cutting and connecting wires.
Ensure all wires and conductive
connection points are free from corrosion before
connecting any wires.
OS
(Open to stop)
CS
(Close to stop)
21
Publicité
