Publicité
Les langues disponibles
Les langues disponibles
Attaching Adapter Plate to Projector
NOTE: The projector you are installing may differ in appearance from the sample illustrated
5
below.
Place projector upside down. Locate adapter plate (B) with notch facing forward as close to
projector center of gravity as possible without covering any mounting holes. Loosen channels
with 4 mm security allen wrench (I), and if there are only three mounting holes remove
fourth channel. Using one channel for each mounting hole, position feet of channels over
mounting holes as shown below. Important: If projector does not have at least three mounting
holes, do not use this adapter plate.
NOTE: Some projectors have feet which can be removed and the corresponding threaded insert
can be used for a mounting hole.
NOTE: Once channels are in position retighten fasteners.
*Notch indicates front of projector.
MOUNTING HOLE
*
GENERIC PROjECTOR
9 of 51
CHANNEL
FOOT OF
CHANNEL
B
ISSUED: 09-30-09 SHEET #: 056-9024-1
Publicité
