Power Connection; Start-Up Procedure; Light Intensity Setting; Maintenance - SCHOTT KL 300 LED Conseils D'utilisation

KL 300 LED – Operating instructions

2.3 Power connection

Insert the hollow plug of the supplied power cord into the
plug-in socket (4) of the light source.
Please take care to ensure that you only operate your KL
300 LED light source with the power cord provided.
The plug connection of the power supply is interchangeable
for the EU, UK, US or AU. This is connected to the mains
supply (100-240 V AC, 50-60 Hz).

2.4 Start-up procedure

2.5 Light intensity setting

The brightness can be adjusted continuously by turning the
light intensity setting knob (7).
Five-step intensity control is possible, from 0 – 5.
The highest brightness is reached at the end stop at position
5.
When the brightness control is set at 0 there is no more
brightness, i.e. the lamp is off.
Attention: Please note that when the brightness control is
set at 0 the instrument is not switched off. When the
instrument is switched on the blue control light (2) is lit. To
switch off the KL 300 LED press the on/off switch (3) once
(see point 2.4 "Start-up procedure"). Please ensure safe
power disconnection by pulling out the power plug!

3. Maintenance

Switch on/off the KL 300 LED by pressing the switch (3).
When the instrument is switched on the blue control light (2) is lit.
Please disconnect power by pulling out the power plug.
6/9