Publicité
MAINTENANCE
- All parts should be checked at least once a month.
has
- Check all nuts and bolts for tightness and tighten when required.
safety
- Check for signs of wear to bolt coverings. If sharp edges are found, replace as required.
- In certain regions (seaside areas), certain coatings could be prone to damage. In this case, it is advised to use a rust
prevention treatment.
- Check swing seats, chains, ropes and other means of attachment for evidence of deterioration; replace when required
in accordance with the manufacturer's instructions.
- All parts that are under constant friction should be oiled regularly using a suitable lubricant.
- The ground on which the play centre is set up should be cleared regularly. All objects such as stones or anything else
cularly
that could cause injury in the case of a fall should be removed.
- It is recommended that during the winter period when the equipment is not in use, all apparatus are removed to
please
prevent deterioration due to bad weather.
- Sand rusted areas and tubular members and repaint using a non-lead based paint when required
- Modi cations to the original activity toy should only be carried out under instructions from the manufacturer.
- Defective parts should only be replaced in accordance with the manufacturer's instructions.
- As timber is a natural product, It will deteriorate in the weather over time. For maximum longevity of your timber, it is
highly recommended to apply an initial 3 coats of a timber protectant such as an exterior grade oil before rst use of the
play set.
etween
All outdoor wooden products require routine inspection and regular maintenance. After installation, a follow-up
inspection should take place after one week and twice a month thereafter for the remaining life of your play products.
ound
Maintenance should be performed at any time it is deemed necessary. As a general rule, major maintenance (wood
re nishing) should be performed at twelve month intervals from the date of installation.
Inspect and perform maintenance based on the following checklist.
Major wooden parts: Inspect for splintering and structure defects at regular intervals. For very minor splinters or
chipping, lightly sanding and re nish with an exterior water repellent stain can assist. If timber has cracked or split signi
cantly, replacement parts may be required, please contact national customer service centre for any replacement
requirements
At regular intervals, the application of a penetrating oil based sealer stain to all wooden components is essential. Please
es,
consult your local hardware or home improvement store for recommendation of an appropriate product. Ensure the
product does not contain hazardous chemicals once dry that can pose a potential health risk to children.
We hope you have a safe and enjoyable time
es, trees,
PRACTICAL ADVICE
Frequent questions and observations
oam and
Safety
to the
Certain safety checks should be carried out regularly on the swing set. This chek should includes, if necessary, removing
any sharp edges, replacing missing screw covers, tightening the nuts and bolts etc, to avoid any danger through normal
wear and tear or any upturning of the swing set.
Comfort
Should the apparatus grate, then apply a suitable gel lubricant. Do not use liquid lubricant as it will run down the
xings and apparatus.
The height of the swing can be adjusted using the plastic eyelet xture. By pulling the rope through the xture, the
height of the seat can be adjusted to suit the user.
Above dimensions are indicative, they can varied according to the assembly method.
It must be used under adult supervision.
Keep the additional components, they could be useful for later operation of maintenance.
ig holes
CAUTION ! Fall danger.
ncrete
1469GE 804168_IM 2015.indd 5
2015-2-5 14:41:19
Publicité
