Inventum VLK401WA Mode D'emploi page 15

Turn the lock lever of the tank to a horizontal position and carefully pull the water
tank out of the appliance to fill it. Fill the water tank with fresh cold water and make
sure that the water level in the water tank does not exceed the maximum level (MAX).
If you place a frozen cooling element in the water tank, make sure the water level does
not exceed the maximum level.
Place the water tank back in the original position and turn the lock lever to the vertical
position.
• Switch on the appliance using the ON/OFF key.
• The indicator light for the lowest speed
• Press the mode key COOLER/HUMIDIFY. The indicator light
• Change the ventilation speed with each press on the button SPEED: low, medium or high.
Extra instructions
• Always use fresh cold water.
• Make sure the water in the water tank does not come below the minimum level (MIN) when using the cooling
or air humidification mode.
HUMIDIFICATION
The appliance is able to humidify the indoor air and thus create a healthy living environment. For a healthy indoor
living climate, the air humidity should be between 40% and 60%. If the air humidity is lower, use the appliance with
the mode HUMIDIFY .
Caution: only use this mode when the water tank is provided with fresh cold water.
Turn the lock lever of the tank to a horizontal position and carefully pull the water tank out of the appliance to fill it. Fill the water
tank with fresh cold water and make sure that the water level in the water tank does not exceed the maximum level (MAX).
Place the water tank back in the original position and turn the lock lever to the vertical position.
• Switch on the appliance using the ON/OFF key.
• The indicator light for the lowest speed
• Press the mode key COOLER/HUMIDIFY 2 x. The indicator light
• The speed of the ventilation cannot be changed when using this mode and is always at the lowest speed.
Extra instructions
• Always use fresh cold water.
• Make sure the water in the water tank does not come below the minimum level (MIN) when using the cooling or air
humidification mode.
SWING MODE
By means of the swing mode you can determine the back and forth movements of the fins for a better air displacement.
• Switch on the appliance at the required mode (cooling, ventilation or humidify).
• Press the swing key
• The up and down wind direction can be adjusted manually.
TIMER
Press the timer key to start the timer. The time period is increased in steps of 30 minutes when you repeatedly press this
key, up to a maximum of 7½ hours.
If, for example, you want to set the air cooler for 5½ hours, you must press down this key until the indicator lights
0.5h + 1h + 4h = 5½ hours light up.
All indicator lights switch off when the entire programme has been completed.
If you want to stop the timer mode or set a new time, you must continue to press the timer key until all indicator lights are off.
When the appliance is on, the timer can be used to switch off the appliance automatically at the required time within the
range from 30 minutes to 7½ hours.
lights up.
lights up.
and the fins move to the left and right continuously.
lights up red.
lights up blue.
15
English •