AIR SYSTEMS INTERNATIONAL BAC-10 Manuel D'utilisation page 4

4
GenerAl SetUP & OPerAtIOn
INTAKE FILTER
INTAKE FILTER
SteP 1)
Install rubber feet on to the pump(s) as shown. Note: The rubber feet are packaged separately for shipment.
SPECIAL SETUP - BAC-10 ONLY
The manifold assembly is packed separately in the same box. Install manifold assembly on the compressor prior to use.
Thread the swivel fitting onto the hex nipple and tighten securely.
SteP 2)
Check intake filter for excessive dirt and change if necessary. Set compressor in a clean environment away from
hazardous dusts, mists, vapors, and fumes.
SteP 3)
Use only constant flow Type-C respirators. Attach hose(s) and mask(s) to system before turning the unit on, failure to do
so will cause internal motor damage.
SteP 4)
Assure that electric service amperage rating is in accordance with electric motor specifications. Plug power cord into 120
VAC outlet and turn switch "on". Note: If extension cords are used, they must be gauged per NEC specifications.
SteP 5)
With the compressor running and respirators attached, loosen the relief valve lock nut. Adjust outlet pressure to the
setting recommended by the respirator manufacturer.
DO NOT EXCEED 15psi output pressure (Models BAC-17 & BAC-20).
DO NOT EXCEED 12psi output pressure (Model BAC-10).
Turn the knob clockwise to increase pressure, counterclockwise to decrease pressure and retighten the lock nut. The unit
is now operational. Note: Do not back the adjustment knob all the way out while unit is pressurized. The loss of internal
parts may occur.