Exotek Instruments MC-160SA Mode D'emploi page 6

PIN-FREE MOISTURE METERS
MANUAL
Wood Group
200
00
400
500
600
700
800
900
1000
1100
MEASURING
PROCEDURE
After selecting the appropriate material-group the unit must be hold up in
the air for automatic 0-correction. The unit is ready for measuring after
about 2 sec.
Hold the spring electrodes without excessive force and in a approx.
40 angel to the material.
o
All of the 3 measuring springs must be in good contact with the
material to be measured.
Measurements may be taken in different spots of the material, or the
measuring springs could be slided across the material.
SELECTING MEASURING MODE
F1 : Measurement without hold function.
F2 : Measurement with hold function
F : Measured value is calculated into Relative
Humidity (only for material codes E1-E5).
F4 : MC measurements are stored and the
average value is calculated.
• " : " is showed in the left corner of the display when a value
is stored.
• The average value is flashing on the display if the blue
button is pushed.
• To reset the memory, push the green button in for 5
seconds ("0.00" is flashing).
ENG
MC-160SA
Density Range
200 – 00 kg/m³
00 – 400 kg/m³
400 – 500 kg/m³
500 – 600 kg/m³
600 – 700 kg/m³
700 – 800 kg/m³
800 – 900 kg/m³
900 – 1000 kg/m
900 – 1100 kg/m
> 1100 kg/m³
- 6 -
40 Degrees
MENU
F1-F4