Publicité
Les langues disponibles
Les langues disponibles
OM 3002BL
CHARCTERISTICS
• Min. H.: 278mm
• Max. H.: 420mm
• Weight: 5.1kg
SAFETY INFORMATION
Please read these safety warnings before operation.
• Failure to heed these warnings may result in a loss of load, damage to the axle stands, and/or personal injury
or property damage.
• Do not overload jack stands beyond their rated capacity.
• Overloading can cause damage or failure of the axle stands.
• Position the load on the centre saddle only, on each axle stand that you use.
• Always use axle stands in pairs, and place on a hard, level surface capable of sustaining the load.
• Use of stands on anything other than a hard level surfacecan result in axle stand instability and possible loss of
load.
OPERATING INSTRUCTIONS
1. Refer to your vehicle owner's manual for proper jacking instructions. Lift only on areas of the vehicle as specified
by the vehicle manufacturer.
2. Position stands under the vehicle at points specified by the vehicle manufacturer as proper load support points.
3. To adjust the stands hold the control lever up while lifting the saddle shaft to the desired height. Push the control
lever down to lock pawl into the teeth loaded in the centre column. Ensure the pawl is fully engaged into the teeth.
4. Carefully lower the load onto the stands.
5. Visual inspection should be made before each use of the stands – checking for cracks, cracked welds and
missing and/or damaged parts. An axle stand that appears to be damaged in any way must be removed from
service immediately.
6. Because of the potential hazards associated with the misuse of this equipment, no modifications should be made
to the product.
PAIR OF 2T JACK STANDS WITH SECURITY PIN
SADDLE
CENTER COLUMN
PAWL
CONTROL LEVER
Publicité
