LEXIBOOK LXB ST600 Mode D'emploi page 4

To Program
Note: all settings will be lost when replacing the batteries. Please keep this user
guide so that you can program the remote again after changing the batteries.
Entering a code manually:
1. Turn on manually the device you wish to program (TV, VCR, SAT, DVD, CAB,
AUD).
2. Using the code list located at the end of this user guide, locate the codes for
the brand name of the device you wish to program.
3. Press and hold the button of the device you wish to program (TV, VCR, SAT,
DVD, CAB, AUD) for more than three seconds; the red LED will illuminate,
indicating that the remote control is ready to accept a 3-digit code.
4. Enter a 3-digit code listed for the brand of your device within 30 seconds; the
LED will shut off, indicating that the remote control is programmed.
5. Press the ON/OFF button to verify if the correct code was entered. If the
device shuts down, no further programming is required.
6. If the device does not respond, repeat Steps 2-5, using a different 3-digit code
listed for that device brand.
Note: please note down the 3-digit code that programmed that remote control
successfully. You will need to program the remote control again after changing
the batteries.
Programming the remote using Power Scan:
With Power Scan programming, the remote control tests all the codes available
in the code list and assigns the correct code for the selected device. Although
this method can be more time consuming, it eliminates the need to look up
codes and enter them manually.
1. Manually put the device you wish to program
(TV, VCR, SAT, DVD, CAB, AUD) in sleep mode.
2. Press and hold the appropriate device key (TV, VCR, SAT, DVD, CAB, AUD)
until the red LED illuminates. This indicates that the remote is in programming
mode.
3. Press and release the ON/OFF key. The LED flashes once and stays ON,
indicating that the remote is in Power Scan mode.
4. Press either the CH+ or CH- button repeatedly until the device switches ON.
The CH+ button searches upward in the code list, while the CH- key searches
downward.
5. When the device turns on, press and release the OK button to store the new
code and exit. To exit without setting the code, press the GO BACK button.
NOTE: If you press CH+ or CH- again after the device turns on, the device will
not be programmed; you will need to repeat Steps 1-5 again.
6. Press any other operable key (VOL+/VOL-). If the device responds, no further
programming is required. If the device does not respond, repeat steps 1-5.
ST600IM
100mm (W) x 150mm (h)
7 8
ST600IM
Reset
WARNING: If the unit malfunctions or receives an electrostatic shock, remove
the batteries and insert them again.
Warranty
NOTE: Please keep this instruction manual, it contains important information.
This product is covered by our two-year warranty. To make use of the warranty or
the after-sales service, please contact your retailer and supply proof of purchase.
Our warranty covers material or installation-related defects attributable to the
manufacturer, with the exception of wear caused by failure to respect the
instructions for use or any unauthorised work on the equipment (such as
dismantling, exposure to heat or damp, etc.).
LEXIBOOK UK ltd,
Unit 10 Petersfield Industrial Estate,
Bedford Road, Petersfield,
Hampshire, GU32 3QA,
United Kingdom,
Freephone helpline: 0808 100 3015,
http://www.lexibook.com
Environmental Protection
Unwanted electrical appliances can be recycled and should not be
discarded along with regular household waste! Please actively support the
conservation of resources and help protect the environment by returning
this appliance to a collection centre (if available).
100mm (W) x 150mm (h)