Philips AZ 2770 Mode D'emploi page 14

CD PLAYER
Programming track numbers
You may store up to 20 tracks in the desired sequence. If you like,
store any track more than once.
1. In the stop position, press SEARCH ¡ or ™ for your desired
track.
2. When your chosen track number appears, press PROG once to
store the track.
– The display shows 'PROG' and '
selected track number.
3. Repeat steps 1. and 2. to select and store all desired tracks in
this way.
Reviewing your set program
• In the stop position, press and hold down PROG for one
second or more.
The display shows all your stored track numbers in sequence.
– You can also review the program during playback.
• To play your program press PLAY/PAUSE 2;.
Erasing a program
You can erase the contents of the memory by:
– pressing the CD door open;
– pressing TUNER or TAPE source button;
– pressing STOP 9 twice during playback/ in stop position
• The display shows '
cancelled.
PLAYING A CASSETTE
1. Press POWER to on position.
2. Press TAPE source button.
– The TAPE indicator lights up.
3. Press STOP/EJECT 9 / to open the cassette holder and
insert a cassette.
4. Press the cassette holder shut.
5. Press PLAY 2 to start playback.
6. Adjust the sound using the VOLUME and DBB controls
7. To interrupt playback press PAUSE ;. To resume, press the key
again.
8. By pressing 5 or 6,fast winding of the tape is possible in
both directions.To stop fast winding, press STOP/EJECT 9 /.
9. To stop the tape, press STOP/EJECT 9 /.
– The keys are automatically released at the end of the tape,
except if PAUSE ; has been activated.
10.Press POWER again to switch off the set.
– The TAPE indicator goes out.
14
' briefly followed by your
' briefly when the program is
CASSETTE RECORDER
CD
TU NE R
STO P
SEA RC H
PROG
PROG
CD
TU NE R
STO P
SEA RC H
TA PE
PRO G
PLA Y/P AU SE
BA ND
FM
MW
CD
CD
CD
TA PE
PRO G
PLA Y/P AU SE