Kimberly-Clark PROFESSIONAL ICON Automatic Mode D'emploi page 7

Strapping Method (continued)
4. Take the type of strapping
preferred and measure a
piece the size of the dispenser
opening. Add extra length to
each side to be able to fold
over the edges.
5. Use metal or plastic strapping
to secure the dispenser in
place. Cut the strapping with
snips to the size desired fold
over the edges on each side.
6. Using the 2" installation screws,
screw both ends of the
strapping to the bottom of the
housing that is in the wall.
7. Carefully remove the cover on
the tape on back of housing.
8. Install the dispenser housing
in the area where the folded
towel dispenser was located.
This dispenser has a lip on top
and it is important to place the
lip over the top of the housing
still left in the wall as shown.
9. Place a level in the bottom of
the dispenser to ensure that
the placement is level. Press
sides firmly.
10. Using a carriage bolt and a 5/8
inch flat washer, tighten the
dispenser to the strap.
4
6.
7.
9.
5.
8.
10.