Maintenance; Cleaning And Sanitizing Interior Bin; Cleaning Exterior Bin - Manitowoc F Serie Mode D'emploi

Cleaning and Sanitizing Interior Bin

Interior of bin must be cleaned and sanitized prior to use
and must be cleaned on a routine basis during use.
Single door upright ice storage bins are equipped with
polyethylene liner walls and stainless steel bottoms
which must be cleaned and sanitized every six months
with Manitowoc Ice Machine Cleaner and Sanitizer.
! Caution
Use only Manitowoc approved Ice Machine Cleaner
and Sanitizer for this application (Manitowoc
Cleaner part number 94-0546-3 and Manitowoc
Sanitizer part number 94-0565-3). It is a violation of
Federal law to use these solutions in a manner
inconsistent with
understand all labels printed on bottles before use.
!
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or
Sanitizer.
1. Remove upper inspection windows by sliding
windows to one side. Grasp the end of the front
window and pull toward you as the window is slid to
the opposite side. Repeat for rear window.
Part Number 000006528 10/09
their labeling. Read
Warning
REAR WINDOW
FRONT WINDOW
Section 4

Maintenance

2. Mix a solution of cleaner and warm water.
Depending upon the amount of mineral buildup, a
larger quantity of solution may be required. Use the
ratio in the table below to mix enough solution to
thoroughly clean all parts.
Solution Type
Cleaner
3. Wash bin walls, hopper, access door plate and rinse
all areas thoroughly with clean water.
Do not rinse after sanitizing.
and
4. Mix a solution of sanitizer and warm water.
Solution Type
Sanitizer
5. Sanitize bin walls, hopper and access door plate.
Use a spray bottle to liberally apply the solution. Do
not rinse the sanitized areas.

Cleaning Exterior Bin

Exterior stainless steel surfaces can be cleaned with a
stainless steel cleaner and polish.
Water Mixed With
1 gal. (4 L) 16 oz. (500 ml)
cleaner
Important
Water Mixed With
3 gal. (11 L) 2 oz. (60 ml)
sanitizer
7