Vonyx VPS Serie Manuel D'instructions page 4

18. SD port
Connect your SD/MMC card in this slot to play music with MP3 or WMA format.
19. USB port
Connect your USB devices to this slot to play music with MP3 or
WMA format.
20. Speaker Output (Active speaker)
Put the plug of speaker cable included into this connector and put
the other plug of speaker cable into passive speaker (24).
21. LED Switch (Active speaker)
Turn on the LED (frontside) of the active speaker on/off.
22. Power Switch
Turn the power on/off.
23. Power input
Before connecting the power cord, check if the mains corresponds to the voltage
indicated on the rating plate on the unit. Connect the power cord only to a mains socket
outlet with a protective earthing connection.
24. Speaker input (Passive Speaker)
Put the plug of speaker cable included into this connector and put the other plug of
speaker cable into active speaker (19).
25. LED Switch (Passive Speaker)
Turn on the LED (frontside) of the passive speaker on or off.
CONNECT BT-DEVICE
If password is required, you can enter "0000".
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
4
1. Set the search function on of the BT device you want to play the music. See the operating
instructions for that device..
Press the "MODE" button until "AUX" will show in display and activate BT-function.
2.
Find on your BT-device "VONYX" and make the connection.
3.
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.