Thomas VAPORO SMILEY Mode D'emploi page 9

Filling up the Water Boiler
when using the Device
If there is no more water in the vessel no steam
is emitted when the steam switch (5) is pressed.
The water has to be filled up as follows:
1. Please turn the device off by moving
the on/off switch (1) to "0".
2. Pull the power plug out of the socket!
3. Wait for approximately 5 minutes and release
the residual pres sure with the steam switch!
4. Open the safety lock (4) slowly while
pressing down at the same time and wait
a few seconds before opening completely
after the overpressure has been relieved.
5. Fill fresh water from the measuring beaker
(9) by means of the fun nel (8) into the boiler.
Do not overfill! Do not exceed the amount
of water indicated on the measuring beaker!
Take care of water splas hes that might come
out of the boiler. In order to prevent the water
from splashing it should be filled into the funnel
slowly after the safety lock has been opened.
6. Fasten the safety lock again.
7. Insert the power plug back into the socket.
Cleaning and Maintenance
• Cleaning and maintenance must only be carried out
when the power plug is removed from the socket.
• Before putting the device away or cleaning it, it
has to be allowed to cool down completely.
• Please clean the device and the accessories
only with a slightly moist cloth.
• Do not use strong cleaning agents
of solvents for cleaning.
• In order to guarantee a long and trouble-free
working life, lime residues have to be rinsed
out of the boiler once a month. Please do not
use vinegar or other anti-liming agents
This device has been tested according to
all relevant current CE guidelines, such as
electromagnetic compatibility and low voltage
directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
9