Nitty-Gritty PASSI TEST PLUS Manuel De L'utilisateur page 17

6.5 C
ALIBRATION
- Exhaustion of the electrolyte contained in the refill  see Par 4 – Refill Replace
- Pollution of the tip (eg. If you performed a test on a piece of dirt)  see Par 5 – Tip Replace
It is recommended to perform the calibration test after a prolonged storage period.
6.6 F T
REE EST
passive layer of stainless steel between a maximum value (GOOD) and totally not passive (BAD).
Press to return to the FREE TEST section or press MENU to return to main menu.
6.7 Q C
UALITY ONTROL
(the field can be left blank, press
possibility to enter the next serial number. To change the value, press
keyboard.
Insert the SERIAL N° and press
After pressing the test will start and a graphic bar will show the progression of the test (duration: 15
seconds).
After testing, the display shows the numeric value of the quality of the passive layer of stainless steel
between a maximum value (GOOD) and totally not passive (BAD).
Press to return to the insertion of the serial number -thus maintaining the current session and the Project
N°- or press the MENU button to end the session and return to the main menu.
NOTE: The tester has 50 memory blocks; once used all the available cells, to perform new QC tests it will be
necessary to clear the memory using the provided software function (see. section 8.3.2 – Deleting Tests –
User ID).
- GB -
To access the calibration control function, from the main menu, select
SETTINGS and press
selection and place the probe on the calibration plate supplied, then press
. A 5 seconds calibration test will start, after which there will be an OK
message confirming proper calibration.
In the eventuality that the calibration cannot be completed, a message to
verify the cartridge and/or tip; CHECK TIP / REFILL will be displayed.
The loss of the calibration can be in fact caused by two factors:
The Free Test function allows to make a passivation test without saving the
data in memory. To access this feature, from the main menu, select NEW
TEST (press ) and then FREE TEST (press
Position the probe on the test piece and press
After pressing the test will start
progression of the test (duration: 15 seconds).
After testing, the display shows the numeric value of the quality of the
From the main menu, select NEW TEST (press
QUALITY CONTROL (press
To access the quality control function, you must login using their username /
password, previously recorded in the Settings section. (see par. 6.4 User ID /
Password setting)
Once logged in, you are requested for PROJECT N°., which will remain
stored during all the tests of the current session. Enter the project No and
press (note: the field can be left blank, pressing the
Than it is required the SERIAL N°. This data will be stored for the current test
); after testing, the instrument will return to this window, giving the
, than position the probe on the test piece and press
16
; scroll with the arrows to the CALIBRATION
).
to begin the test.
and a graphic bar will show the
)
and enter the data using the
) and subsequently
key)
to begin the test.