Mopar Navus 2 Instructions De Montage

N
avus
Using the Suction Cup Mount
Use the Navus 2 accessory mount to move your Navus 2 from one location to another. You
can affix the mount to any smooth, non-porous surface. If no smooth, non-porous surface is
available, use the enclosed disk to mount the Navus 2.
Mounting the Navus 2
Position the mount and the cables so that they do not interfere with the controls or safe
operation of the location. Select a position where the Navus 2 has a relatively unobstructed
view of the sky.
To mount the Navus 2:
1. To ensure a tight grip, clean and dry the mounting surface.
2. Pull the lever on the suction cup toward you. Place the suction cup on the mounting
surface. Flip the lever toward the mounting surface.
3. Align the ball on the end of the suction mount with the socket (hole) on the back of the
Navus 2.
4. Press firmly to snap the ball into the socket.
5 Rotate the Navus 2 to obtain a maximum viewing angle.
6. Plug the power cable into an available receptacle. Your unit should turn on automatically
if it is plugged in and your vehicle is running.
See the back of this page for instructions on using the enclosed disk to mount the Navus 2.
2 a
™
ccessory
/M M
ariNe
Mounting Surface
Lever
i
ouNt NstructioNs
Suction
cup tab
Suction
cup