Audizio RP315 Manuel D'instructions page 5

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and
all packing materials. In the event that the product must be returned to the factory, it is important that the product be
returned in the original factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. Lift lever
Push the lift lever backwards to be able to raise the tone-arm.
Gently move the tone-arm to the desired position over the
record. The platter will begin to spin when the arm is moved
towards the record. Push the lift lever forwards to be able to
lower the tone-arm slowly onto the desired position on the
record to begin playing the record. Please note: The record will
only begin to spin when the tone-arm is moved towards the
record if the Auto Stop function is turned on.
2. Tone-arm clip
This specially designed arm clip secures the tone-arm while at
rest or when not in use. The arm clip has been designed to
remain in the up position while unlocked.
3. Autostop Switch ON/OFF
This switch turns auto stop on or off. When the automatic stop
is enabled, the platform will start rotating as soon as the tone
arm is placed over the record and will stop rotating when it
has reached the end of the record. Some vinyl records stop
before the end or do not stop when the end is reached. In this
case set Auto-stop function to OFF.
4. LED indicator
5. Speed/function knob
Knob to select phono- or BT-mode. Turn the knob to BT for BT-
mode. For phono mode, turn the knob to 33 or 45 rpm.
6. Power indicator
7. Power/volume knob
Turn the knob to turn on/off- and set the volume of the
turntable.
8. Tone arm head
9. Platter shaft
10. Cartridge with needle
When the turntable is not in use, it is recommendable to place the removable protection cover over the stylus.
11. Platter
Place your record here.
12. RCA line output
The sound signal from long-playing record is sent to this line output. Connect this signal to the line input of an such as an
amplifier or a line input of a CD/DVD player.
13. DC input
Connect the power adapter.
1. Connect the record player with the power adapter and plug the other end into a wall power outlet.
2. Gently remove the white protective needle cover.
3. Turn the power & volume control knob clockwise to turn on the record player.
4. Select phono mode by turning the function knob to 33 or 45 rpm.
5. Place a vinyl record on the turntable platter and select the desired speed (33/45RPM) according to the record.
6. Open the tone arm clip to release the tone arm. Push the lift lever backwards to raise the tone arm and gently move the
tone arm to the desired position over the record. The turntable will begin to spin when the tonearm is moved towards the
record (when the AUTO STOP switch is ON). Push the lift lever forwards to lower the tone arm slowly onto the desired
position on the record to start playback.
7. Turn the volume control knob to adjust the volume.
Noted: If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control
is turned OFF, record will NOT stop automatically when finished.
5