Hathaway HUSTLER 7 Instructions D'assemblage page 5

ASSEMBLY INSTRUCTIONS
1. Begin LEG assembly by attaching the LEG TOP BOARD #4 and LEG BASE BOARD #5 to the cleats
on two LEG SIDES #2, using the pre-drilled holes with 1-5/8" SCREWS #7, as shown below.
Attach LEG PANEL #3 to the assembled leg frame, using pre-drilled holes, with FLAT HEAD SCREW #16.
Do NOT overtighten screws. Repeat assembly for remaining LEG.
#7
Note: The Leg assembly may require two individuals, one to hold pieces, while the other inserts screws.
TIP: If you hand insert all screws, on a single piece, into pre-drilled holes before tightening, it will help
hold the pieces in alignment as you tighten the screws.
2. Attach each assembled LEG to the bottom of the TABLE BODY #1 with LARGE BOLT #15 and
5/16" FLAT WASHER #6.
3. Thread two LEG LEVELERS #14 on to the bottom of each LEG. Carefully turn table over.
#7
#5
#7
#2
#2
#4
#7
#1
16
#
#3
#14
#6
#15
#3
#2
5