Hathaway MONTECITO Instructions D'assemblage page 6

THANK YOU! CARE AND USE / CLIMATIC ADJUSTERS
Begin the adjustment process by placing a straight edge across the playfield directly above the first
climatic adjuster at each end of the table. This will determine if the playfield is concave or convex.
The shuffleboard surface should be slightly concave to prevent the pucks from falling off the sides.
To Correct a Convex Playfield
To Correct a Concave Playfield
Please note that the shuffleboard will react to the adjustments for several days. Check the playfiled again
to determine if further adjustments are needed. DON'T try to make adjustments too quickly all at once, this
may break adjusters or crack board.
1. Loosen Nut B completely.
2. Tighten Nut A a turn or two slowly.
Do the same to each other pair of adjusters
in rotation, for a gradual and uniform effect.
3. Repeat the process a few times, as
necessary, waiting a day or two for the wood
to react, until the play surface is true with
straight edge.
4. Re-tighten Nut B.
1. Loosen Nut A completely.
2. Tighten Nut B a turn or two slowly.
Do the same to each other pair of adjusters
in rotation, for a gradual and uniform effect.
3. Repeat the process a few times, as
necessary, waiting a day or two for the wood
to react, until the play surface is true with
straight edge.
4. Re-tighten Nut A.
6